New STRACK locking plates for slide holding devices
Locking plates are designed to significantly simplify the insertion of the latching groove in the slide. The time -consuming milling with a form cutter is eliminated, because the nut is already optimally incorporated in these plates. They are simply screwed in a pocket in the bottom side of the slide. Because the STRACK -locking plates consist of hardened steel, no wear on the slide or the mould plate occurs.
The round version Z5131 for the round slide holding devices Z5129 + Z 5130 is available in the three sizes: diameter 13, 18, 27 mm.
The rectangular version Z5141 for the slide holding device Z5140 is available for sizes from 38 – 56 mm length.
 |
-
VMM s.r.o.
STRACK Normalien standard parts, parts for molds and cutting process tools, Mastip hot runner systems, components for molds, single-purpose equipment.
Trends in plastic injection moulding: venting structures
7.2.2025 In plastic injection moulding, most of the venting takes place through the parting planes. However, conventional venting solutions are often not sufficient, resulting in low injection efficiency and part quality problems.
