New nozzles Thermoplay for fast cycles
JAN SVOBODA s.r.o. offers new nozzles for fast cycles from Thermoplay.
- Special nozzle and valve gate solution for application in "fast cycles".
- Improved sealing to compensate injection pressure increase in fast cycle production.
- Increased melt channel inside the nozzle, to get faster injection rate.
- Better thermal exchange between pin and cavity plate to get faster cooling of the gate area.
- Mechanical clamping even when the system is not thermally expanded in case of accidental cold start up.
- Available for FN (diam.24, 32) and DN (diam. 22, 30) nozzles.
- To improve the benefit of this solution a conformal cooling bushing is also available.
- Typical applications of these special solutions are thin wall products which require both high injection speed and fast cooling cycles.
 |
Contact:
Ing. Jan Svoboda
+420 724 286 611
svoboda@jansvoboda.cz
www.jansvoboda.cz
Author: JAN SVOBODA s.r.o.
-
JAN SVOBODA s.r.o.
Complex deliveries of semi-finished products for molds for plastics, tools for molding plastics and light metals, machine tools, tempering equipment,...
Trends in plastic injection moulding: venting structures
7.2.2025 In plastic injection moulding, most of the venting takes place through the parting planes. However, conventional venting solutions are often not sufficient, resulting in low injection efficiency and part quality problems.
